Professional

Print Version

100% Acrylic Low Sheen

Additional Information

USES
Ideally suited for walls and ceilings.

SURFACE PREPARATION
BEFORE PAINTING: Ensure surface is firm, properly prepared, thoroughly dry, dust free, clean and free of all foreign matter. If necessary, fill all nail holes, cracks, etc. with a suitable filler, sand smooth and dust down.
Efflorescence or mould on any surface must be treated first.

Brick, Masonry, Fibro, Gyprock, etc.
New unpainted – Remove dust, loose sand, etc. especially from cement render by rubbing with a block of oregon timber and sweep clean. Apply one coat of Duralex Premium Undercoat & Wallboard Sealer followed by two coats of Duralex 100% Acrylic Low Sheen.

Exterior Timber
New unpainted - Duralex 100% Acrylic Low Sheen is not recommended for use on exterior timber. In these areas one coat of Duralex 100% Acrylic PRIMER Undercoat followed by two coats of Duralex Sun Master Gloss or Sun Master Low Sheen, is recommended.

Previously Painted Surfaces
Before recoating previously painted surfaces, ensure that the surface is firm. Unsound surfaces should be stripped before repainting to achieve the best results. Test at random for its ability to withstand extra coats. Simply cut a small cross (x) through the paint with a razor blade, then place a piece of sticky tape firmly over the cut. Hold the side of the tape then rip the tape off. If the tape pulls the surface away, the surface is unsound. Test different areas before deciding whether or not the surface coating should be removed. After removing all loose, flaking paint and powdery deposits, apply Duralex Surface Binder where necessary. Sand glossy surfaces to provide a key. Prime any bare interior timber or rust-prone metal surfaces with Duralex 100% Acrylic PRIMER Undercoat and rust-prone metal surfaces with a suitable primer. Apply two coats of Duralex 100% Acrylic Low Sheen.

APPLICATION
Stir contents thoroughly before and during use with a broad flat stirrer, using an upward lifting action. To ensure best performance, do not use any additive not approved by Duralex. Avoid excessive brushing or roller pressure and disturbing freshly laid paint which has begun to dry. Do not overspread.
Thinning with up to 10% water may be necessary when painting outside during hot weather or when painting highly absorbent surfaces, or if ropiness or roller stipple is experienced.
NOTE: If stopping for a short break, insert paint and roller in a plastic bag to avoid paint drying out. This will provide for a smoother, nib free job.

DRYING TIME
Normally dries in 20 minutes in dry, well ventilated areas and may be recoated after 2 hours. In damp or humid conditions drying time is lengthened – Remember ventilation is important.

COVERAGE
A maximum coverage rate of 16 square metres per Litre per coat. This may fall below 10 square metres per Litre when painting corrugated, rough or absorbent surfaces.

CLEAN UP
Wash all equipment with clean water. Any dried spots may be removed using methylated spirits.

WEATHER CONDITIONS
Surface temperature must be above 10°C during application and drying time. Duralex 100% Acrylic Low Sheen must be at least two hours dry before dew, fog or rain when used outside.

COLOURS
Available in White only, which is compatible with all major tinting systems. Tinter, if added, should be shaken and stirred in thoroughly immediately after addition.

CAUTION
Allow adequate cross ventilation when painting indoors during and after use to dissipate water vapour.

SIZES
20, 10, 6, 4 Litre.

ENVIRONMENT
Low odour. Low V.O.C. Environmentally friendly.

IMPORTANT
Keep out of reach of children. To avoid spoilage of paint, keep container sealed when not in use.

---

	Low Lustre A unique low sheen that can save ONE THIRD of TIME and MONEY as it has 1.5 times the opacity of normal acrylic paint. Pastel colours are obtained by adding 1½ times the normal amount of tinter. Washable interior/exterior acrylic with approximately 6% sheen. For exterior timber use Duralex Sun Master Low Sheen.
	Matt Lustre This product can save ONE THIRD of TIME and MONEY as it has 1.5 times the opacity of normal paint. Pastel colours are obtained by adding 1½ times the normal amount of tinter. Washable interior/exterior acrylic flat. Also available in black.
	Squash Court Paint A specially developed and independently tested water-based flat paint for squash court walls with superior ability to resist marking of either ball or wall.
	Line Marking Tape Red tape for line marking squash courts.